GLOBE 3100 MANUALE INSTALLAZIONE
11
PROGRAMMAZIONE DI FABBRICA
1 NON USARE
-
-
3 SIRENA MONOTONALE FISSA
4 SIRENA MONOTONALE ALTERNATA
5 SIRENA BITONALE
6 SIRENA TIPO SWEEP
attiva
attiva
attiva
attiva
disattiva
disattiva
disattiva
disattiva
clacson
sirena
1 NON USARE
2 NON USARE
1 NON USARE
2 DISPOSITIVO EMISSIONE ALLARME
-
clacson
-
sirena
KITKIT
Sistema con sirena
Lampeggio corto
Lampeggio lungo
3 MODALITA' EMISSIONE ALLARME CLACSON
continua
alternata
Sistema senza sirena
Lampeggio lungo
Lampeggio corto
Lampeggio lungo
Lampeggio corto
TABELLA SIRENE
FITTING INSTRUCTION GLOBE 3100
18
Bonnet switch
The bonnet switch must be installed to facilitate programming of the alarm and of the radio
control auto-learning. Check that the switch is depressed by at least 5 mm. when the bonnet
is closed. Ensure that the switch is not acting against sound proofing as these materials
could deform over time.
Antenna
The position of the antenna is of fundamental importance to the operation of the radio
controls.
The wire must not be cut, wound, connected to other wires or to the bodywork and must be
kept separate from the wiring harness. Position the antenna at least 20 mm. far from metallic
parts.
Emergency Button Panel / LED
Install on the dashboard in an accessable position. The LED should be visable from outside
the vehicle. In addition to its deterrent function, the panel (LED + push button) is used for
programming and for emergency override.
ELECTRICAL CONNECTIONS
ATTENTION!
Disconnect the negative terminal from the battery before starting the installation
of the system. This system is compatible with 12 Volt negative ground vehicles
Refer to the enclosed wiring diagrams, and take note of the following:
• Route the alarm wires along side the original vehicle harness.
• The system ground must be connected to an original vehicle ground point.
• Connect the alarm unit negative and positive feed before reconnecting the car battery.
• The positive supply to the system, must be protected by an adequate fuse located close
to the point of connection (see main diagram).
To Next Page
Loading...
Need help?
General