Cobra MicroTalk Operating Instructions

OPERATION
ENGLISH
OPERATION
Using the Scan Function (continued)
To scan privacy codes:
1. While in Standby mode, press the
CHANNEL SELECT button up or down to
choose the main channel you wish to scan.
2. Press the MODE
button until the
Scan icon and the
privacy code
number flashes.
3. Push the CHANNEL SELECT button up or
down and the radio will begin scanning
privacy codes within the main channel you
selected.
4. The radio will continue to scan privacy codes
and stop if an incoming transmission is
detected. The radio will remain on that code
for ten (10) seconds. During that time you can:
a) Press and hold the TALK button and
talk. The radio will remain on that
channel and privacy code, then return
to Standby mode.
b) Push the CHANNEL SELECT button up or
down to resume scanning privacy codes.
c) Press the MODE button to proceed to
memory location scanning (see below).
If you do not press any button within ten
(10) seconds, the radio will automatically
resume scanning privacy codes.
To scan memory locations:
1. Press the MODE button until the Scan
icon, Memory Location icon and memory
location number flashes.
2. Push the CHANNEL SELECT button up or
down and the radio will begin scanning
memory locations.
3. The radio will continue to scan all memory
locations and stop if an incoming
transmission is detected. The radio will
remain on that location for ten (10)
seconds. During that time you can:
a) Press and hold
the TALK button
and talk. The
radio will
remain on
that memory location channel and return
to Standby mode.
10
ENGLISH
9
MODE
Button
TALK Button
b) Push the CHANNEL SELECT button
up or down to resume scanning
memory locations.
c) Press the MODE button to proceed
to other functions.
If you do not press any button within ten
(10) seconds, the radio will automatically
resume scanning memory locations.
You must have at least two (2) memory
locations programmed in order to scan
memory locations.
(NOTE: If you want to reduce the number
of memory locations being scanned you need
to ”unprogram“ all unwanted locations by
changing both the main channel and privacy
code to 00. See Programming Memory
Locations, page 8.)
“Roger Beep” Confirmation Tone
Your listener will hear an audible tone when
you release the TALK button. This alerts the
other party that you are finished talking and
it is OK for them to speak. This feature can
be turned On or Off.
To turn “Roger Beep” On or Off:
When turning On your microTALK
®
radio for
the first time, “Roger Beep” will be On.
1. Press the MODE button until the “Roger
Beep’’ icon flashes on the LCD. The current
On or Off setting is displayed.
2. Press the CHANNEL
UP or CHANNEL
DOWN button to
select “Roger
Beep” On or Off.
3. a) Press the MODE button to enter
the new setting and proceed to
other functions.
b) Press the LOCK button to enter the new
setting and return to Standby mode.
c) Do not press any buttons for
15 seconds to enter the new setting
and return to STANDBY MODE.
The setting you select will be saved
when you turn your radio Off and On again.
When the “Roger Beep” is On, the “Roger
Beep” icon will be displayed.
CHANNEL SELECT
Button
MODE
Button
CHANNEL
SELECT
Button

Cobra MicroTalk Specifications

General

Brand	Cobra
Model	MicroTalk
Category	Two-Way Radio
Language	English