Cobra MicroTalk Operating Instructions

OPERATION•ADVANCED FEATURES OPERATION
ENGLISH
8
Programming Memory Locations
Your microTALK
®
radio has ten (10) memory
locations (0-9) for storing your most
frequently used channels and privacy codes.
To program locations:
1. Push the MODE
button until the
Memory icon and
the memory
location flashes.
2. Select the memory
location you wish
to change by
pushing the
CHANNEL SELECT
button up or down.
3. Press and release
the MODE button
again. The Memory
icon and the main
channel number
will flash.
4. Select the main channel you wish to
store by pushing the CHANNEL SELECT
button up or down.
5. Press the MODE
button again to store
the main channel in
memory andmove
to privacy code
selection. The privacy code number begins
flashing and the Memory icon continues to
flash.
6. Select the privacy code (00-38) you wish
to store by pushing the CHANNEL SELECT
button up or down.
7. Press the LOCK
button to program
your selection.
You may also press
the TALK button to
transmit your
selected channel and privacy code, which will
be stored into the memory location you are
using. (NOTE: To “unprogram” a memory
location you programmed previously, select
00 for both the main channel and privacy
code in steps 4 through 6.)
8. Press and release
the LOCK button to
return to Standby
mode at your new
memory location,
or press and release
the MODE button to save the memory
location and proceed to other functions.
ENGLISH
7
MODE
Button
CHANNEL
SELECT
Button
TALK Button
Recalling Memory Locations
To recall a channel you have
stored in a memory location:
1. Press the MODE
button until the
Memory icon
and a memory
location flashes.
2. Select your desired
memory location
by pushing the
CHANNEL SELECT
button up or down.
Your radio will stay
at this memory location until you exit
Memory Function mode by pressing the
LOCK button.
3. Repeat steps 1 and 2 to recall other
memory locations.
Using the Scan Function
Your microTALK
®
radio can automatically scan
main channels (1-22), the privacy codes (00-
38) within one main channel, or memory
locations.
To scan main
channels:
1. Press the MODE
button until the
Scan icon and main
channel number flashes.
2. Push the CHANNEL SELECT button up or
down and the radio will begin scanning
the main channels. (NOTE: The radio
“ignores” privacy codes while scanning
main channels.)
3. The radio will continue to scan all
main channels and stop if an incoming
transmission is detected. The radio will
remain on that channel for ten (10)
seconds. During that time you can:
a) Press and hold
the TALK button
and talk. The
radio will
remain on that
channel and
return to Standby mode.
b) Push the CHANNEL SELECT button
up or down to resume scanning
main channels.
c) Press the MODE button to proceed to
privacy code scanning (see following page).
If you do not press any button within ten
(10) seconds, the radio will automatically
resume scanning main channels.
TALK Button
LOCK
Button
MODE
Button
LOCK Button
MODE
Button

Cobra MicroTalk Specifications

General

Brand	Cobra
Model	MicroTalk
Category	Two-Way Radio
Language	English