Battery Installation
To Install or Replace Batteries:
1. Remove belt clip by releasing belt clip latch and
sliding clip Up.
2. Pull down on the BATTERY DOOR LOCK TAB to
remove the battery compartment cover.
3. Insert four (4) AAA batteries. (Always use high-quality alkaline batteries.) Position batteries according to polarity
markings.
4. Replace Battery Compartment cover and belt clip.
NOTE: See “Optional Accessories” for accessory availability and ordering instructions.
Battery Charging
When the optional NiMH battery pack (part No. FA-BP) is used, the
batteries can be charged using the optional rapid wall mount charger
(part No. PA-CW). Simply place the battery pack in the battery
compartment, open the CHARGE TAB on the side of the unit and insert the
plug into the charge jack to start charging. The batteries should be fully charged in about three (3) hours.
WARNING: Only the NiMH battery pack FA-BP can be recharged.
NOTE: See “Optional Accessories” for accessory availability and ordering instructions.
Radio Power
To Turn Your Radio On:
1. Press and hold the POWER button until you hear a series of audible tones indicating
that the radio is On.
Your microTALK
®
radio is now in LISTENING MODE, ready to receive transmissions. The radio is
always in LISTENING MODE, except when the TALK, CALL or MODE/LOCK buttons are pressed.
To Turn Your Radio Off:
1. Press and hold the POWER button.
OPERATION
English
Lock Tab
Power Button
Remove Belt Clip Insert Batteries
Charging BatteriesCharge Tab
To Next Page
Loading...
Need help?
General
