Cointra CPA 11 User Manual

6cod.
3541S050 - Rev. 01 - 07/2019
EN
CPA
Failure of the
ignition/detecti
on electrode
Check the
electrode
cable, and
make sure
it's
properly
connected
and free of
deposits.
Defective gas
valve
Check
and/or
change
the gas
valve.
Activation of
the
overtemperat
ure protection
Damaged or
badly positio
ned heating
sensor
Check that
the
heating
sensor
is properly
installed
and
operating
and/or
change it.
Activation of
the flue
gas
thermostat
(after this
operation, the
Flue gas ther
mostat con
tact open
Check the
thermostat
.
Cables di
sconnected
Check the
connection
s.
unit is reset
by turning on
the tap, and
the
thermostat
cools off).
Thermostat
obstructed or
incorrectly si-
zed
Check the
thermo
stat.
Probe
disconnected
Check the
con-
nection or
change
the probe.
2 INSTALLATION MANUAL
2.1 General information
The heater may only be
installed by an authorized
technician, in accordance
with all instructions
contained in this manual,
standard UNE 26, and local
installation and exhaust
regulations.
2.2 Location
Make sure the water heater chosen is the
most suitable:
• To adequately meet the system’s hot water
requirements.
• For the gas to be used (see water heater
dataplate).
• For the water supply pressure, necessary
for operation (see table of characteristics).

Cointra CPA 11 Specifications

General

Brand	Cointra
Model	CPA 11
Category	Boiler
Language	English