To Operate
•This rechargeable pump needs to be charged for 10
HOURS (but no more than 24 hours) before first use.
Charge only using transformer provided with the
pump.
•Do not leave pump charging for more than 24 hours
to avoid damage to the battery.
•After use, recharge pump within 48 hours.
•Always store pump with a full charge. To keep the
battery at optimum operating levels, recharge the
unit every 3 months, even if it has not been used.
•Pump will not operate when charger is plugged in.
Inflat ing Colema n
®
Double Lock ™ Valve
Fig. 1
Fig. 2
Fig. 3
Fig. 4
1. To begin inflation, open external cap and pull firmly
on the lanyard to extend out. This will open internal
yellow seal. (Fig. 1)
2. Attach adapter nozzle to inflation end of pump.
Insert pump and turn on. (Fig. 2)
Note: The pump may look different from yours. It
is for illustration purposes only.
3. When fully inflated, seal valve by pushing in with
pump nozzle. This will seal the internal yellow
stopper and keep air from escaping while closing
cap. Gently twist adapter sleeve to right while
backing pump out of valve. (Fig. 3)
4. Fully remove pump and close external cap. Valve
should appear depressed into itself. (Fig. 4)
Deflat ion
Remove adapter nozzle from inflation end and
attach to deflation side of pump. Repeat same steps
as inflation. This will draw the air out quickly. (Fig. 5)
Fig. 5
Inflating Standard Pinch Valve
•Attach pinch valve adapter
to inflation end of pump.
•Insert pinch valve adapter
into pinch valve. (Fig. 6)
•Make sure tip of adapter
is extended past inner “Flap”
inside of valve. Turn pump on.
•When fully inflated, remove pump from valve and
seal valve.
Other Valves
This pump is compatible with most valves on
inflatable products. If you have an inflatable
product with a valve other than those described
above, rotate the adapter sleeve until nozzle end
fits valve.
About the Battery
This product uses a lead acid, sealed, rechargeable
battery. The battery pack is recyclable. At the end
of the battery pack’s useful life, the unit should be
recycled or properly disposed of. Do not discard
in a landfill or incinerate. Contact your local city
officials for battery disposal information.
Fig. 6
4010045471 (ECN20060957-02)
Please call or write us with any comments or questions:
Coleman Brands Pty. Ltd.
Unit 5-6, 13 Lord Street,
Botany NSW 2019
Australia
Telephone: 1800 224 350
Email: customerservice@colemanaust.com.au
www.colemanaustralia.com.au
Made in China
© 2017 The Coleman Company, Inc. All right reserved.
Coleman
®
,
, and are registered trademarksand
QuickPump™, Double Lock™, QuickBed™ and Wrap ‘N’ Roll™ are
trademarks of The Coleman Company, Inc.
To Previous Page
Loading...
