GETTING STARTED
Attaching the StrikePack F.P.S. Dominator
1. Ensure your PS4 controller is off.
2. Line up the USB ports, flip the securing
arm out of the way, and slide the PS4 F.P.S.
Dominator onto the back of the PS4 controller.
3. Swing the arm to the front of the controller and
gently secure the curved arm of the device
by gently pressing it against the front of the
controller. It should lock into place in the
speaker holes and you should hear a soft “click”.
4. Your StrikePack F.P.S. Dominator is now ready to be paired to your console.
Pairing the StrikePack F.P.S. Dominator with your Console
NOTE: As the StrikePack device is a highly advanced wired adapter, it must be paired
each time the console is turned on, or brought out of STANDBY MODE. This is a very
simple process and takes seconds.
1. Ensure your StrikePack device is attached to the controller but NOT plugged in.
2. Turn on your PS4 console via your controller or front power button.
3. At the login screen, you will see the message “DualShock 4 wireless controller
connected. Who is using this controller?” Press your X button as you normally would.
4. You will notice an icon of the controller with a battery symbol appearing on the top
left of your screen indicating that a wireless controller is now connected.
5. Using the supplied 10FT cable, plug in the standard USB cable end to a free USB port
on the front of your console.
6. Plug the smaller custom port into the USB port on the StrikePack.
7. You should see a controller icon appear in the top left of your screen with a battery
symbol and now a Headset symbol. This is because the StrikePack device has its own
built in audio system that it uses.
8. You will see the wired controller connected message and be asked “who is using this
controller?” just as you did at login. Select your user and press X again. You will notice
that there is a controller symbol and headset symbol at the bottom left of your profile.
To Next Page
Loading...
Need help?
General
