ComAp InteliGen 200 User Manual

InteliGen 200 Global Guide
4
LOAD. Green LED is ON if load is supplied by mains or by generator. It means, that Gen-set or
mains is OK and proper circuit breaker is closed.
Graphic B/W display, 132x64 pixels.
MAINS status indicator. There are two states - Mains OK (indicator is green) and Mains failure
(indicator is red). Green LED is on, if mains is present and within limits. Red LED starts blinking
when the mains failure is detected and after the gen-set has started and connected to the load it
lights permanently until the mains failure disappears.
MCB ON. Green LEDs are on if MCB is closed and Mains is healthy. If Mains is not healthy and
MCB is closed than middle LED is on. It is driven by MCB CLOSE/OPEN output or by MCB
feedback signal.

ComAp InteliGen 200 Specifications

General

Brand	ComAp
Model	InteliGen 200
Category	Controller
Language	English