8 9
RECOMMENDATIONS
FOR INSTALLATION
INSTALLATION
Make sure that the thermostat is installed in a living area.
Where do you install the COMAP Smart Home thermostat?
• In an occupied room, usually in the living room
• Do not install against an outside wall or in draughty spaces
• Between 1.2 and 1.5 m from the ground
• Keep away from doors, wall cupboards or other objects that may interfere with the
presence detection sensor.
• Place the thermostat in a place where it cannot be exposed to direct sunlight.
• If you have pets, place the thermostat away from furniture they can sit on so that they
are not detected by the presence detection sensor.
Recommended locations
Connect the gateway to the modem using the two cables supplied.
Note: If the modem does not have a
USB port, you can connect the gateway
to the mains using a 5V DC USB charger
/ minimum 200mA (not supplied).
Connect the gateway
Both LEDs on the gateway should light up:
• The power light on the le indicates that the gateway
is being powered
• The communication light on the right indicates that there
is a good internet connection.
1
To Next Page
Need help?
General