Assembly (continued)
Insert Hose
Insert the hose locking end of the
"Pos-I-Lock" hose into the inlet of the
Vac. The hose should snap into place.
To remove the hose from the Vac, press
the release button in the hose assembly
and pull the hose out of the Vac inlet, as
shown.
PRESS &
PULL
Release
Button
Accessory Storage
Your Craftsman Wet/Dry Vac caddy is
designed to provide better stability and
accessory storage. There are six storage
locations at the rear of the Vac caddy,
two storage locations on caster feet and
two storage locations on the Vac lid.
Conveniently store accessory nozzles
and extension wands on the rear of the
caddy and use the front storage for hose
storage and/or male-to-male and air
diffuser storage.
To Next Page
Loading...
Need help?
General
