Operation
WARNING
To reduce the risk of fire or explosion, do not operate this vac in areas with
flammable gases, vapors or explosive dust in the air. Flammable gases or
vapors include but are not limited to; lighter fluid, solvent type cleaners, oil-
base paints, gasoline, alcohol or aerosol sprays. Explosive dusts include but
are not limited to; coal, magnesium, grain or gun powder. Do not vacuum
explosive dust, flammable or combustible liquids or hot ashes. Do not use
this vac as a sprayer for any flammable or combustible liquid. To reduce the
risk of health hazards from vapors or dusts, do not vacuum toxic materials.
CAUTION: To reduce the risk of
hearing damage wear ear protectors
when using the vac for extended
hours or when using it in a noisy
area.
The operation of any utility vac can
result in foreign objects being
blown into the eyes, which can
result in severe eye damage. Always
wear safety goggles complying with
ANSI Z87.1 (shown on package)
before commencing operation.
Safety Goggles are available at
Sears retail stores.
Your Craftsman two gallon wet/dry vac is
assembled at the factory and ready for
use when you remove it from the carton.
The unit is ready for dry vacuuming or
blowing. After you plug the power cord
into the wall receptacle, turn the unit "ON"
by pushing the switch from position "0" to
position "1". The symbols used on the
switch are international symbols. The "0"
is the "OFF" position and the "1" is the
"ON" position.
To Next Page
Loading...
Need help?
General
