Unpacking and Checking Carton Contents
Remove entire contents of carton. Check
each item against the Carton Contents
List. Notify your Sears Store immediately if
any parts aredamaged or missing.
Carton Contents List
Key Description Qty.
A Vac Assembly .............................. 1
B Hose Assembly ............................ 1
C Utility Nozzle ................................ 1
*D Caster Storage ........................... 4
E Caster ........................................... 4
F Owners Manual ........................... 1
G Filter Cage ................................... 1
H Filter ............................................. 1
I Float ............................................. 1
J Filter Plate .................................... 1
K Filter Nut ....................................... 1
* Some models provided with caster foot
storage
K
0
D
Float/Cage Assembly
WARNING: For your own safety,
never connect plug to power source
outlet until all assembly steps are
complete and your have read and
understood the safety and operation
instructions. Do not operate vac with
any ports damaged or missing.
• Remove the top section ofi he vac from
the drum and the drum itself out of the
carton. Place the top section of vac
upsidedown intothe drum or place on a
clean smooth surface.
2. Locate the float. Place the float over the
opening in the center of the lid with the
words ,'This Side Towards Lid" laying
face down over the hole.
WARNING:To avoid personal injury
or damage to vac be sure to keep
hands,fingers, or any other foreign
objects out of the center opening
whenassemblingthe float.
and press the blade against one of the
filter cage tabs. Push in on the tab and lift
the filter cage up. Tilt the filter cage
slightly away from the open slot to release
the other two tabs. Pull the filter cage
away from the lid. To replace, follow
float/cage assembly instructions.
Filter
,Cag_Tabs
\ ,_ i / Float
3i Line up filter cage tabs to the slots in
the center ring of the lid assembly.
4: Push on the filter cage until the tabs
snap into the slots for a secure fit.
NOTE: If the filter cage needs to be
removed, because the float is placed in
the wrong way, use a slotted screwdriver
To Next Page
Loading...
Need help?
General
