AI" nment
7) "
Square Blade to Table for
Crosscutting
The goal of this adjustment is to make the
blade square to the table so that crosscuts
will be accurate; otherwise all crosscuts will
have a slight bevel angle.
1. Lower blade until it just clears front table.
Lock bevel, miter, rip, and yoke locks.
2. Place a framing square on the table with
the short leg against the saw blade and long
leg parallel to fence. Do not allow the square
to rest against a "set-out" tooth; it must rest
flat against the blade side.
3. If the saw blade is square with the table
top (no visible gap appears between the saw
blade and square) no adjustment is required.
Set bevel indicator to 0 ° reading. If the
square does not touch the saw blade as
shown (with square leg held firmly against
the table top), perform the following adjust-
ments:
Rip
Fence
Bevel
Indicator
Square
(Place parallel
to fence)
Square I_\ t
I I I
Correct / i
!
Wrong
J
J
Wrong
a. Tighten rip lock knob.
b. Remove handle by removing 5/16-18
socket head screw and lockwasher.
c. Slightly loosen the four socket head
screws with 1/4" Hex "L" Wrench. Rotate
motor while holding square firmly against
saw blade and table top.
d. Slightly tighten each of the four screws
and recheck...Now tighten each screw
tight.
e. Reinstall handle and adjust indicator to
0° reading.
f. Loosen rip lock knob.
_ Loosen these
four screws
:_->'J_ Head Screw
5/16" Lockwasher
114" Hex "L" Wrench
(Supplied)
31
To Next Page
Loading...
Need help?
General