2 3
To avoid electrical hazards, fire hazards or damage to the tool, use proper
circuit protection.
This tool is wired at the factory for 110-120 Volt operation. It must be
connected to a 110-120 Volt / 15 Ampere time delay fuse or circuit breaker.
To avoid shock or fire, replace power cord immediately if it is worn, cut or
damaged in any way.
Before using your tool, it is critical that you read and understand these
safety rules. Failure to follow these rules could result in serious injury to
you or damage to the tool.
PRODUCT SPECIFICATIONS
MOTOR
Power Source ............................................................. 1.6 A, 120 V AC, 60 Hz
Speed Control............................................................. Electric
TABLE
Tilt..........
...................................................................... 45
0
Left
SAWDUST BLOWER
................................................. Yes
BLADE
Speed.......................................................................... 400~1600 SPM
Type.............................................................................
Pin-end or Plain-end
Length.......................................................................... 5 in.
Depth of Throat............................................................
16 in.
Blade Stroke................................................................ 3/4 in.
Depth of 45
0
Cut.......................................................... 1 in.
Depth of 90
0
Cut.......................................................... 2 in.
WARNING
!
To Next Page
Loading...
Need help?
General