19
SERVICE AND MAINTENANCE
WARNING
If the engine has been recently run, the engine, muffler and sur-
rounding metal surfaces will be hot and can cause burns to the skin.
Exercise caution to avoid burns.
WARNING
Before performing any type of maintenance/service, disengage all
controls and stop the engine. Wait until all moving parts have come to
a complete stop. Disconnect spark plug wire and ground it against the
engine to prevent unintended starting. Always wear safety glasses during
operation or while performing any adjustments or repairs.
Follow the maintenance schedule given below. This chart describes
service guidelines only. Use the Service Log column to keep track of
completed maintenance tasks. To locate the nearest Sears Service
Center or to schedule service, simply contact Sears at
1-800-4-MY-HOME®.
Interval Item Service Service Log
Before Each Use Engine oil level1.
Muffler area and controls2.
Check1.
Clean2.
In the First Five Hours Engine Oil1. Change1.
Every 10 Hours Hood/ Dash air vents1.
Battery terminals2.
Deck spindles and idler 3.
bracket
Clean1.
Clean2.
Lubricate3.
Every 25 hours Air filter’s precleaner*1.
Air filter*2.
Mid steering arms, pivot 3.
shafts, and axles
Front wheel bearings4.
Front deck wheels5.
Clean1.
Clean2.
Lubricate 3.
Lubricate4.
Lubricate5.
Every 50 hours Engine oil1.
Muffler2.
Change1.
Check2.
Annually Air filter1.
Air filter’s pre-cleaner2.
Spark plug3.
Air cooling system*4.
Fuel filter5.
Steering Gears6.
Rear Wheels7.
Replace1.
Replace2.
Replace3.
Clean4.
Replace5.
Clean6.
Remove and grease axles7.
Before Storage Hood/ Dash air vents1.
Battery terminals2.
Mid steering arms, pivot 3.
shafts, and axles
Front wheel bearings4.
Front deck wheels5.
Deck spindles and idler 6.
bracket
Pedal pivot points7.
Clean1.
Clean2.
Lubricate 3.
Lubricate4.
Lubricate5.
Lubricate 6.
Lubricate7.
*Service more frequently under dusty conditions.
WARNING
Before performing any maintenance or repairs, disengage the PTO
(Blade Engage knob), engage the parking brake, stop the engine and
remove the key to prevent unintended starting.