7
ENGLISH
Fig. 6
11. For quiet operation, install the noise
diffuser
16
into the blower port
1
by
inserting the locking end of the diffuser
into the blower port
1
and turning
clockwise to lock into place.
12. Plug the power cord into the outlet.
Turn the motor on by flipping the on/off
switch
9
to the ‘I’ ON position and begin
vacuuming. Fig. 7.
Fig. 7
WARNING:
ONCE YOU HAVE
COMPLETED VACUUMING, FLIP THE ON/
OFF SWITCH TO THE ‘O’ OFF POSITION AND
UNPLUG THE POWER CORD FROM THE
OUTLET. O = OFF I = ON
BLOWER OPERATION
This Wet/Dry Vacuum has blowing capabilities.
To use the blower feature follow the instructions
listed.
WARNING:
ALWAYS WEAR
SAFETY GOGGLES COMPLYING WITH ANSI
Z87.1 (OR IN CANADA, CSAZ94.3) WHEN
USING BLOWER.
WARNING:
KEEP BYSTANDERS
CLEAR FROM BLOWING DEBRIS.
WARNING:
WEAR A DUST
MASK IF BLOWING CREATES DUST THAT
MIGHT BE INHALED.
WARNING:
VERIFY THAT THE
POWER CORD IS DISCONNECTED FROM THE
OUTLET.
CAUTION:
MAKE SURE THE
COLLECTION TANK IS EMPTY BEFORE
USING AS A BLOWER. CLEAR ALL DIRT AND
DEBRIS FROM THE HOSE AND COLLECTION
TANK.
13. Remove the hose
12
from the vacuum port
7
. Remove the noise diffuser
16
from the
blower port
1
.
14. Insert the larger end of the hose
12
into
the blower port
1
on the back of the
power head and lock into place. Fig. 8.
Fig. 8
15. Choose the desired accessory and insert
onto the end of the hose
12
. Fig. 9.
Fig. 9
To Next Page
Loading...
Need help?
General
