Craftsman WS210 User Manual

8
ASSEMBLY
INSTALLING THE CUTTING HEAD SHIELD
Model No. WC210 / CMXGTAMD25CC
1. Remove the wing nut and washer from the cutting head shield.
2. Insert the short tab (the one without a hole) on the mount
bracket into the slot on the cutting head shield (Fig. 1).
3. Rotate the cutting head shield counterclockwise to align the hole
on the cutting head shield with the hole on the mount bracket
(Fig. 1).
4. Insert the square bolt into the hole underneath the cutting head
shield (Fig. 2). Push the square bolt through the cutting head
shield and mount bracket.
5. Place the washer onto the square bolt (Fig. 2).
6. Screw the wing nut onto the square bolt until the cutting head
shield is firmly in place (Fig. 2).
Fig. 1
Mount Bracket
Cutting Head
Shield
WARNING:
To prevent serious personal injury, never
operate the unit without the cutting head shield in place.
Fig. 2
Washer
Square Bolt
Slot
Wing Nut
Cutting Head
Shield
Mount Bracket
INSTALLING THE CUTTING HEAD SHIELD
Model No. WS210 / CMXGTAMD25SC
1. Remove the wing nut and washer from the cutting head shield.
2. Insert the short tab (the one without a hole) on the mount
bracket into the slot on the cutting head shield (Fig. 3).
3. Rotate the cutting head shield until the bolt on the cutting head
shield protrudes through the hole on the mount bracket (Fig. 3).
4. Place the washer onto the bolt (Fig. 4).
5. Screw the wing nut onto the bolt until the cutting head shield is
firmly in place (Fig. 4).
WARNING:
To prevent serious personal injury, never
operate the unit without the cutting head shield in place.
Fig. 3
Mount Bracket
Cutting Head
Shield
Fig. 4
Washer
Bolt
Slot
Wing Nut
Tab
Bolt
Hole

Craftsman WS210 Specifications

General

Brand	Craftsman
Model	WS210
Category	Trimmer
Language	English