Creality CR-X Technical Notes

Australia New Zealand
www.jaycar.com.au www.jaycar.co.nz
techstore@jaycar.com.au techstore@jaycar.co.nz
1800 022 888 0800 452 922
Page
3
of
3
TL4410
CR-X Technical Notes
Blockages should not occur at the nozzle and should be more prone to other areas;
which can be easily removed by disassembling the nozzle assembly. TH1766 would
help with this, as with TD2132.
Thermocouple errors usually show through abnormally high temperature readings while
the nozzle is still cold to touch. It is held in place by a small screw located on the side of
the nozzle.

Creality CR-X Specifications

General

Build Volume	300 x 300 x 400 mm
Layer Resolution	0.1-0.4 mm
Filament Diameter	1.75 mm
Nozzle Diameter	0.4 mm
Extruder Type	Dual Extruder
Bed Leveling	Manual
Nozzle Quantity	2
Printing Technology	FDM (Fused Deposition Modeling)
Heated Bed	Yes
Connectivity	USB, SD card
Supported Materials	PLA, ABS, TPU, Wood