EasyManuals Logo
Home>Cub Cadet>Lawn Mower>13WZ92AK056

Cub Cadet 13WZ92AK056 User Manual

Cub Cadet 13WZ92AK056
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
Problem Cause Remedy
Engine fails to start 
2.
Spark plug wire(s) disconnected. 
Throttle control lever not in correct starting 4.
position.
Choke not activated 5.
Fuel tank empty, or stale fuel. 6.
Blocked fuel line. 7.
Faulty spark plug(s). 8.
Engine flooded. 9.
Fuse(s) blown.

Engage parking brake. 2.
Connect wire(s) to spark plug(s). 
 4.
Move the Throttle/Choke Control into choke 5.
position.
6.
old) gas.
Clean fuel line and replace fuel filter. 7.
Clean, adjust gap or replace plug(s). 8.
Crank engine with throttle in FAST position. 9.
Replace fuse.
Engine runs erratic  
Spark plug wire(s) loose. 2.
Blocked fuel line or stale fuel. 
Vent in gas cap plugged. 4.
Water or dirt in fuel system. 5.
Dirty air cleaner. 6.
Move Throttle/Choke Control out of the 
choke position.
Connect spark plug wire(s). 2.
Clean fuel line; fill tank with clean, fresh 
gasoline and replace fuel filter.
Clear vent or replace cap if damaged. 4.
Drain fuel tank. Refill with clean, fresh 5.
gasoline.
Replace air cleaner paper element or clean 6.
foam pre-cleaner.
Engine overheats Engine oil level low. 
Air flow restricted. 2.
Fill crankcase with proper amount and 
weight of oil.
Clean grass clippings and debris from around 2.

Engine hesitates at high

Spark plug(s) gap too close.  Remove spark plug(s) and reset the gap. 
Engine Idles rough Spark plug(s) fouled, faulty or gap too wide. 
Dirty air cleaner. 2.
Replace spark plug(s). Set plug gap. 
Replace air cleaner element and/or clean 2.
pre-cleaner.
Excessive vibration Cutting blade loose or unbalanced. 
Damaged or bent cutting blade. 2.
Tighten blade and spindle. 
Replace blade. 2.
Mower will not mulch grass Engine speed too low. 
Wet grass. 2.
Excessively high grass. 
Dull blade. 4.

Do not mulch when grass is wet. 2.
Mow once at a high cutting height, then 
mow again at desired height or make a
narrower cutting swath.
Sharpen or replace blade. 4.
Uneven cut Deck not leveled properly. 
Dull blade. 2.
Uneven tire pressure. 

Sharpen or replace blade. 2.
Check tire pressure in all four tires. 
Troubleshooting
8
29

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cub Cadet 13WZ92AK056 and is the answer not in the manual?

Cub Cadet 13WZ92AK056 Specifications

General IconGeneral
BrandCub Cadet
Model13WZ92AK056
CategoryLawn Mower
LanguageEnglish

Related product manuals