Cub Cadet 1527 User Manual

SECTION8: SERVICE
HeadLamp
WARNING: If the engine has been recently
run, the engine, muffler and surrounding
metal surfaces will be hot and can cause
burns to the skin. Allow the tractor to cool and
use caution when changing the lamp bulbs.
Replace headlight bulbs as follows:
NOTE: Pay attention to which wire connects to each
lamp terminal before disconnecting.
Unplug the wire harness leads from the lamp
socket terminals. See Figure 23.
To remove the bulb & socket from the reflector
housing, align the tab of the socket with the notch of
the reflector, then push the socket inward and turn
as follows to unlock:
Left lamp -- 1/4 turn counterclockwise.
Right lamp -- 1/4 turn clockwise.
With the terminals pointing upward, align the tab of
the replacement bulb & socket with the notch of the
reflector. Push then socket inward and turn as
follows to lock:
Left lamp -- 1/4 turn clockwise.
Right lamp -- 1/4 turn counterclockwise.
Re-connect the wire harness leads to the
appropriate socket terminals.
Socket Tab
Terminal
Socket
Reflector
Notch ector
Housing
Figure 23
Tires
_, WARNING: Never exceed the maximum
inflation pressure shown on the sidewall of the
tire.
The recommended operating tire pressure is:
approximately 10 psi for the rear tires and
approximately 14 psi for the front tires.
Refer to the tire sidewall for exact tire manufacturer's
recommended or maximum psi. Do not overinflate.
Uneven tire pressure could cause the cutting deck to
mow unevenly.
Cutting
Blades
WARNING: Be sure to shut the engine off,
remove ignition key, disconnect the spark
plug wire(s) and ground against the engine to
prevent unintended starting before removing
the cutting blade(s) for sharpening or
replacement. Protect your hands by using
heavy gloves or a rag to grasp the cutting
blade.
WARNING: Periodically inspect the spindle
bolts and housings for cracks or damage,
especially if you strike a foreign object.
Replace immediately if damaged.
The blades may be removed as follows.
Remove the deck from beneath the tractor, (refer to
CuttingDeckRemovalon page 25) then gently flip the
deck over to expose its underside.
Place a block of wood between the center deck
housing baffle and the cutting blade to act as a
stabilizer. See Figure 24.
Hex Flange Nut
Spindle Assembly
Figure 24
Use a 1-1/8" wrench to remove the hex flange nut
that secures the blade to the spindle assembly. See
Figure 24.
24

Cub Cadet 1527 Specifications

General

Brand	Cub Cadet
Model	1527
Category	Lawn Mower
Language	English