Cub Cadet 1863 User Manual

LUBRICATION GUIDE
A WARNING
The life of any machine depends upon the care it is given. Proper lubrication is a very important part of
that care.
Be certain that all lubrication fittings are assembled in
place, using the lubrication illustrations as a guide.
Always lubricate the tractor thoroughly before taking it
to the field. Use a pressure lubricating gun.
Be sure all fittings are free from dirt and paint so the
lubricant is certain to enter the bearing.
Always force the lubricant through the full length of
each bearing until it emerges at the end, carrying with
it the worn lubricant and any dirt that may have
entered the bearing.
Miscellaneous working parts not provided with lubrica¬
tion fittings should be oiled daily with a good grade of
lubricating oil.
Lubricant is cheap. Use plenty of it. Worn parts can
be expensive to replace.
Keep your supply of lubricating oil and grease stored
in clean containers, and covered to protect from dust
and dirt.
Keep the lubricating gun nozzle clean and wipe dirt
from grease fittings before lubricating.
The symbols in the illustration indicate the method of
application and the hourly intervals to apply the lubri¬
cant.
Use a pressure lubricating gun
and apply 251H EP grease (or
equivalent No. 2 multi-purpose
lithium grease) sufficient to
flush out the old grease and
dirt. Lubricate at hourly inter¬
vals indicated on symbols.
Dipstick, use to check engine
oil before each use.
1. Engine filler cap and
dipstick
2. Steering knuckles (2)
(Both sides)
3. Transmission oil filter
4. Front axle pivot bolt
(Right side)
—Before Each Use
Check the oil (with the engine stopped) and add sufficient new oil to bring it to the
’’FULL" mark on the dipstick. Do not overfill. Do not operate the engine if the oil
level is below the "LOW" mark on the dipstick.
—After Every 10 Hours of Operation
Use 251H EP grease or equivalent No. 2 multi-purpose lithium grease and apply
sufficient grease to flush out old grease and dirt.
NOTE: After the first 10 hours only, remove the transmission oil filter and replace
with a new filter. Refer to "MAINTENANCE." Change the transmission oil filter
after 50 hours and every 100 hours of operation thereafter.
Use 251H EP grease or equivalent No. 2 multi-purpose lithium grease and apply
sufficient grease to flush out old grease and dirt.
NOTE: It may be necessary to rotate the front axle to reach the grease fitting.
36

Cub Cadet 1863 Specifications

General

Brand	Cub Cadet
Model	1863
Category	Lawn Mower
Language	English