Cub Cadet 1863 User Manual

G. D EPRESS LEFT PEDAL INDICATOR
This indicator will illuminate when an attempt is made
to start the tractor with the brake pedal not fully
depressed.
H. S P E ED CONTROL LEVER
■ ^NOTE
Do not rest your foot on the brake pedal
while driving the tractor as this would cause
the speed control lever to return to the "N"
position.
The lever is used to select any speed from a standstill
"N" position to eight miles per hour in the forward
direction and four miles per hour in the reverse direc¬
tion.
Moving the speed control lever forward provides
increased forward speed, and moving the lever rear¬
ward provides the reverse speeds. (See Figure 3.)
I. L IFT HEIGHT INDICATOR
The lift height indicator will indicate the height of deck
attachment when installed. (See Figure 4).
LIFT
HEIGHT
Figure 4
J. I GNITION/LIGHT SWITCH
A WARNING
Remove the key from the tractor when the
tractor is not in use to prevent accidental
starting and battery discharge.
The combination lights and ignition switch is a four-
position switch. (See Figure 5.)
Figure 5
K. TILT WHEEL RELEASE LEVER
The tilt wheel release lever is used to adjust the steer¬
ing wheel forward away from the operator or rearward
towards the operator. Refer to ADJUSTING THE
STEERING WHEEL in Section III.
L. CHOKE CONTROL
The choke control is operated manually. Pull knob out
to choke engine. Push knob in to open choke. (See
Figure 3.)
M. D OWN STOP ADJUSTMENT ROD
The down stop adjustment rod adjusts the downward
travel of the lift shaft assembly which allows an
attached mower deck to return to a preset height.
(See Figure 6.)
Figure 6
With the implement at a desired height, turn the down
stop adjustment rod clockwise until it stops turning
9

Cub Cadet 1863 Specifications

General

Brand	Cub Cadet
Model	1863
Category	Lawn Mower
Language	English