To Next PageTo Next PageTo Previous PageTo Previous Page
What to do if my Cub Cadet 260 Trimmer has poor trimming performance?
If your Cub Cadet Trimmer is experiencing poor trimming performance, it might be due to the trimmer line being too short or worn (replace the trimmer line), or a worn or damaged spindle belt (replace the spindle belt).
Why my Cub Cadet 260 engine won't start?
If your Cub Cadet Trimmer engine won't start, here are a few things to check: * Make sure the control lever is engaged. * See that the spark plug boot is connected. * Ensure the fuel tank has clean, fresh gasoline. * If equipped with a primer, prime the engine as shown in the Operation section. Other potential causes include a faulty spark plug (clean, adjust the gap, or replace it), a blocked fuel line (clean it), a flooded engine (wait a few minutes before restarting, without priming), a closed fuel valve (open it), or the engine not being choked (choke it).
Why is my Cub Cadet 260 engine running so erratic?
If your Cub Cadet Trimmer engine is running erratically, it could be due to a loose spark plug boot (connect and tighten it), a blocked fuel line or stale fuel (clean the fuel line and refill with fresh gasoline), a plugged vent in the gas cap (clear the vent), or water/dirt in the fuel system (drain the tank and refill). Also, check if the unit is running with the choke applied (push the choke knob in).
How to stop Cub Cadet 260 Trimmer from overheating?
If your Cub Cadet Trimmer engine is overheating, ensure the engine oil level is adequate by filling the crankcase with the proper oil. Also, check for any restrictions to airflow and clean the area around and on top of the engine.
What causes my Cub Cadet 260 to idle poorly?
If your Cub Cadet Trimmer idles poorly, the spark plug may be fouled, faulty, or have a gap that is too wide. Reset the gap to .030” or replace the spark plug.
Why does my Cub Cadet 260 Trimmer have excessive vibration?
If your Cub Cadet Trimmer has excessive vibration, check if the spindle wing nuts are loose and tighten them. If the vibration continues, the spindle may be damaged, and you should consult an authorized service dealer.
What to do if Cub Cadet 260 occasionally skips at high speed?
If your Cub Cadet Trimmer occasionally skips (hesitates) at high speed, the spark plug gap may be too close. Adjust the gap to .030”.
Essential rules for safe operation, handling, and use of the trimmer.
Guidelines for safe trimming on slopes, avoiding steep or wet conditions.
Keep children away from the trimming area and be alert to their presence.
Table listing common issues and their remedies for engine and performance.
General
