Self-Propelled Mower
9
7. FRONT AXLE
7.1. Disconnect and ground the spark plug wire.
7.2. Take measures to prevent fuel from leaking from
the gas tank.
7.3. Remove the front wheels.
7.4. Remove the hairpin clip that holds the height
adjuster linkage from the left front wheel and dis-
connect the linkage. See Figure 7.4.
7.5. Remove the four screws holding the front axle
on. See Figure 7.5.
7.6. Slide the front axle assembly out.
7.7. Reverse the covered process to install the front
axle.
7.8. Run the mower before returning it to service.
Figure 7.4
Remove wheel
Remove
hair pin clip
Figure 7.5
four screws
To Previous Page
Loading...
Need help?
General
