12 Section 3 — ASSembly & Set-Up
Figure 3-9
Drive Control
The adjustment wheel is located in the drive control handle
housing and is used to tighten or loosen the drive belt. You will
have to adjust the drive control if any of the following happens:
1. The mower does not propel itself with the drive control
engaged.
2. The mower’s drive wheels hesitate with the drive control
engaged.
If either of these conditions occur, rotate the adjustment wheel
clockwise to tighten and counter-clockwise to loosen cable to
adjust the drive control. See Fig. 3-9.
NOTE: For some people the drive control may not be in a
comfortable position. You can adjust the handle by tightening
the adjustment wheel.
Set-Up
Gas and Oil Fill-Up
Refer to the separate engine owner’s manual for additional
engine information.
1. Add oil provided before starting unit for the first time out
of the box.
2. Service the engine with gasoline as instructed in the
separate engine owner’s manual.
WARNING: Use extreme care when handling
gasoline. Gasoline is extremely flammable and the
vapors are explosive. Never fuel the machine
indoors or while the engine is hot or running.
Extinguish cigarettes, cigars, pipes and other
sources of ignition.
To Next Page
Loading...
Need help?
General
