Disconnect the spark plug wire and
ground it against the engine before performing any
repairs.
Maintenance
Engine
maintenance instructions.
Air Cleaner
conditions. Clean it every hour under extremely dusty conditions.
air cleaner should be serviced. To service the air cleaner, refer to
Tines
Clean the underside of the tine shield after each use. The dirt
washes off the tines easier if rinsed off immediately instead of
after it dries. Always towel dry the tiller afterwards and apply a
light coat of oil or silicone to prevent rusting or water damage.
NOTE: Never use a “pressure washer” to clean your tiller. Water
can penetrate tight areas of the tiller and its chain case and cause
serious damage to machine.
Lubrication
Pivot Points
Remove the belt cover and lubricate all the pivot points and
linkages at least once a season with light oil. Keep the belts free
of lubrication.
Tine Shafts
Remove the tine assemblies and lubricate the tine shafts at least
once a season.
Wheel Shafts
Remove the wheel assemblies and lubricate the axle shafts at
least once a season.
Chain Drive
The chain drive is pre-lubricated and sealed at factory.
Adjustments
Cable Adjustment
From time to time you may need to adjust the tension on the
Disconnect and ground the spark plug wire against the
engine.
Adjust either the forward or reverse clutch cable by 2.
loosening the hex nut. See Fig. 6-2.
Maintenance & Adjustments
6
14
To Next Page
Loading...
Need help?
General
