Cub Cadet GT 2000 User Manual

Assembly & Set-Up
3
9
NOTE: 
features may vary by model. Not all features in this manual are
applicable to all tractor models and the tractor depicted may
differ from yours.
Tractor Set-Up
Moving The Tractor Manually

relief valve for occasions when it is necessary to move the

transmission to bypass its normal route, allowing the rear tires

follows:
Locate the hydrostatic bypass rod in the rear of the tractor. 

2.
to lock it in place.
NOTE: 
bypass rod is pulled out. Return the rod to its normal position
prior to operating the tractor.
CAUTION: Never attempt to move the tractor
manually without first opening the hydrostatic relief
valve. Doing so will result in serious damage to the

Attaching the Steering Wheel
For shipping purposes, the tractor is crated with the steering

material from the seat. Cut the ties securing the steering wheel
and remove any packaging material. Install the steering wheel as
follows:
Locate the steering wheel.
2.

Check that the tractor front tires are in the straight position. 
If not, temporarily slide the steering wheel onto the
steering shaft and straighten the front wheels. Carefully
remove the steering wheel.
4.

the steering wheel and press the steering wheel onto the

5.
through the center hole of the steering wheel and thread
into the steering shaft. Fully tighten the hex screw into the
steering shaft.
6.

snaps into place on the steering wheel.
Figure 3-1
Contents of Crate
  

Steering Wheel Cover
(Models not equipped
with power steering)
Hex Screw
Bell Washer
Steering Wheel
Steering Shaft
Steering Wheel Cap
(Power Steering Models)
Figure 3-2

Cub Cadet GT 2000 Specifications

General

Brand	Cub Cadet
Model	GT 2000
Category	Lawn Mower
Language	English