Controls & Features
4
11
Hood Lift Notch
Key Switch Module
PTO (Blade Engage)
Control Switch
Forward Control Pedal
Reverse Control Pedal
Parking Brake Lever
Deck Lift Lever
Fuel Fill Cap
Hydro Transmission
Bypass Rods
Fuel Level Window
Seat Adjustment Lever
Cup Holder
Cargo Net
Brake Pedal
Choke Control Knob
Throttle Control
Systems Indicator
Monitor/Hour Meter
12V Power Outlet
Figure 4-1
NOTE: Any reference in this manual to the RIGHT or LEFT side of
the tractor is observed from operator’s position.
Systems Indicator
Monitor/Hour Meter
Your tractor is equipped with a
Systems Indicator Monitor. The
monitor records the accumulated
hours of tractor operation, and
displays the information on the LCD
hour meter display (tenths of an
hour - right most digit). The monitor
also has four indicator lights that show the status of various
functions of the tractor.
HOURS 1/10
PTO
/
B
L
A
D
E
PA
R
K
B
R
A
K
E
O
I
L
BATT.
The system indicator monitor features are as follows:
LCD Hour Meter Display
The hour meter display is activated when the key switch is turned
to either the “NORMAL MOWING” or the “REVERSE CAUTION
MODE” switch positions. When the key switch is turned to an on
position, the battery indicator light briefly illuminates and the
battery voltage is briefly displayed. The display then changes to
the accumulated hours.
NOTE: A record of the actual hours of operation should be kept
to assure maintenance procedures are completed according to
the schedule in this manual.
The Indicator Monitor will also remind the operator of
maintenance intervals for changing the engine oil. The LCD will
alternately flash the recorded hours, “CHG” and “OIL” for five
minutes, after every 50 hours of recorded operation elapse. The
maintenance interval lasts for two hours (from 50-52, 100-102,
150-152, etc.). The LCD will flash as described for five minutes
every time the tractor’s engine is started during this maintenance
interval. Follow the oil change intervals provided in the engine
manual.
To Next Page
Loading...
Need help?
General
