Belt Replacement
Your tiller has been engineered with a belt designed for long
life and optimal performance. It should never be replaced with
a non-OEM belt. Order all belts through an authorized service
dealer or by contacting Customer Support as instructed on page
2.
Disconnect and ground the spark plug wire against the 1.
engine.
Remove the belt cover from the left side of the tiller by 2.
removing the two screws from the top of the belt cover.
See Fig. 7-1.
Remove the hex cap nut and flat washer from the front side 3.
of the belt cover. Remove the hex head screw at the back of
the cover. See Fig. 7-1.
Remove the belt keeper assembly located behind the 4.
engine pulley by removing the two hex bolts and lock
washers.. See Fig. 7-2.
Remove the idler pulley by removing the bolt and nut. See 5.
Fig. 7-2.
Remove the old belt and install the new belt. Follow the 6.
instructions in reverse order to re-install the belt keeper
and belt cover. See Fig. 7-2.
NOTE: Upon reassembly, make certain the belt is routed over the
idler pulley and inside of belt keepers by the engine pulley.
Off-Season Storage
If the tiller will not be used for a period longer than 30 days, the
following steps should be taken to prepare the tiller for storage.
Clean the exterior of the engine and the entire tiller •
thoroughly. Lubricate the tiller as described in the
Lubrication instructions.
Using a pressure washer to clean your tiller is not •
recommended. The washer may cause damage to the
electric components, spindles, pulleys, bearings or the
engine. Using a pressure washers will result in shortened
life and reduce serviceability.
Refer to the Engine Operator’s Manual for the correct •
engine storage instructions.
Wipe the tines with an oiled rag to prevent rust.•
Store the tiller in a clean, dry area. Do not store next to •
corrosive materials, such as fertilizer.
NOTE: When storing any type of power equipment in an
unventilated area or metal storage shed, care should be taken
to rustproof the equipment. Using a light oil or silicone, coat the
equipment and especially any springs, bearings, and cables.
Screws
Nut and washer
Screw
Figure 7-1
Idler Pulley
Belt
Belt Keeper
Engine Pulley
Figure 7-1
Service
8
20
To Next Page
Loading...
Need help?
General
