EasyManuals Logo

Cub Cadet SERIES 1000 LT1042 User Manual

Cub Cadet SERIES 1000 LT1042
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
SECTION9: OFF-SEASONSTORAGE
Clean and lubricate the tractor as instructed in Section7:
MAINTAININGYOURLAWNTRACTORon page 19 of this
manual before storing for an extended period.
Engine
If the engine will be out of service for two months or
more, use the following storage procedure:
Clean the exterior surfaces of the engine. .
Change the oil and filter while the engine is still
warm from operation. Refer to ChangingtheEngine011
on page 19.
The fuel system must be completely emptied, or the
gasoline must be treated with a fuel stabilizer such
as STA-BIL® to prevent deterioration. If you choose
to use a stabilizer, follow the manufacturers
recommendations, and add the correct amount for
the capacity of the fuel system. Fill the fuel tank with
clean, fresh gasoline. Run the engine for 2-3
minutes to get stabilized fuel into the carburetor.
To empty the system, run the engine until the tank
and system are empty.
WARNING: Drain fuel only into an
approved container outdoors, away from an
open flame. Allow engine to cool. Extinguish
cigarettes, cigars, pipes, and other sources of
ignition prior to draining fuel.
Remove the spark plug. Add one tablespoon of
engine oil into the spark plug hole. Install the plug,
but do not reconnect the plug wire. Crank the
engine two or three revolutions.
Store the engine in a clean, dry place.
WARNING: Never store the machine or
fuel container indoors where there is an open
flame, spark or pilot light such as on water
heater, furnace, clothes dryer or other gas
appliance.
SECTION10: MAINTENANCECHART
Before After Initial Every Every Every Every Prior
Each Use 24 Hours 10 Hours 25 Hours 100 Hours Season to Storing
Clean Hood/Dash Louvers _
Check Engine Oil Level
Clean and Re-oil Air
Filter's Foam Precleaner _I'
Replace Air Filter Element _
Change Engine Oil & Filter ,_
Clean Battery Terminals J
Lube Front Axles and Rims _ _P'
,/
Clean Engine Cooling Fins
Lube Front Deck Wheels
Lube Deck Spindles
¢
Lube Pedal Pivot Points _'
Check Spark Plug _' _'
,/Change Transmission Oil*
*On models equipped with drain port
26

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cub Cadet SERIES 1000 LT1042 and is the answer not in the manual?

Cub Cadet SERIES 1000 LT1042 Specifications

General IconGeneral
Cutting Width42 inches
TransmissionHydrostatic
Deck MaterialSteel
Turning Radius18 inches
Cylinders1
DriveRear-wheel drive
Blades2
EngineKohler Courage
Cutting Height1.5 - 4 inches
Warranty3 years

Related product manuals