25
Product Features and Descriptions
No Rethread Harness
The ATON G has a Headrest that automatically adjusts the Harness height without the
need to undo and rethread the Harness. Using the seat's No Rethread Harness, the
Headrest may be adjusted up and down through 11 positions to t your baby.
The ATON G is shipped in the lowest position with the Infant Insert (pg. 28) already in
position.
1. Unbuckle the Harness and Chest Clip, then
drape the Harness over the sides of the
Infant Car Seat Shell.
2. Place the child in the Infant Car Seat,
making sure their back and bottom are ush
with the Car Seat and the Buckle Strap is
snug against the child but NOT under the
child's bottom.
3. Adjust for your baby by pulling up on the
No Rethread Harness Adjuster Handle
AA while sliding the Headrest up until the
Harness Slots are even with or slightly
below your child's shoulders.
IMPORTANT: For proper use of the Infant Car Seat, the Harness Straps MUST be AT
OR JUST BELOW your child's shoulders (see pg. 9).
4. Buckle and snug Harness.
NOTE: Regularly check for proper Harness height as your child grows.
AA
To Next Page
Loading...
Need help?
General
