D-Link DFE-530TX User Manual

TroubleshootingA-2
7. If the card doesn’t “wake up” when it should, the reason
might be that your computer’s BIOS is not fully
ACPI-compliant. Your first step should be to contact
your computer dealer or motherboard maker to see if
you need to upgrade your computer’s BIOS. Contact the
D-Link’s technical support if you are sure you have the
latest ACPI-compliant BIOS and the problem persists.
The DFE-530TX Adapter features three LED indicators to
assist in the resolving of network diagnostics:
•
LINK/ACT Indicator
A steady
green
LED indicates that the card is receiving
power and there is a good link between the DFE-530TX
and the device it is connected to. The LED will flash
when the adapter is sending or receiving data.
•
100M Indicator
This LED shows steady
green
(ON) when operating at
100Mbps. It is
dark
(OFF) when connected at 10Mbps.
•
FULL (duplex) Indicator
This LED is ON for full duplex connections and OFF
when connected at half duplex.

D-Link DFE-530TX Specifications

General

Interface	PCI
Standards	IEEE 802.3, IEEE 802.3u
Data Transfer Rate	10/100 Mbps
Connector	RJ-45
Device Type	Network adapter
Form Factor	Plug-in card
Data Link Protocol	Ethernet, Fast Ethernet
Cable Type	10Base-T, 100Base-TX
Full Duplex Support	Yes
LED Indicators	Link/Activity
Operating System Support	Windows, Linux
Ports	1 x RJ45