D-Link GO-SW-5E Quick Installation Guide

GO-SW-5E & 8E
3
ENGLISH
PRODUCT SETUP
SWITCH SET-UP
Step 1
Connecting the power adapter
Plug the power adapter into a free wall socket, then plug the other
end of the power adapter cable into the power port of the GO-SW-
5E/8E. The power LED will light up, conrming that the device is
powered up successfully.
Step 2
Connecting your Network Devices
Use a LAN cable to connect your network device to one of the
Ethernet ports of GO-SW-5E or GO-SW-8E.
Step 3
Determine that the Switch is Powered On
The Power LED indicator light is green when the Switch is receiving
power; otherwise, it is off.
Determine that the Network Devices are Connected
The Link/Act LED indicator light is green when the port is connected to a
device.
The green indicator blinks as data is transmitted or received.
RouterInternet
LED

D-Link GO-SW-5E Specifications

General

Switch type	Unmanaged
Switch layer	-
Power connector	DC-in jack
Installed SFP modules quantity	0
Basic switching RJ-45 Ethernet ports type	Fast Ethernet (10/100)
Basic switching RJ-45 Ethernet ports quantity	5
10G support	No
Full duplex	Yes
Networking standards	IEEE 802.3, IEEE 802.3az, IEEE 802.3x
MAC address table	2000 entries
Power consumption (typical)	0.9 W
Number of power supply units	1
Product color	White
LED indicators	Activity, Link
Storage temperature (T-T)	-10 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	47.85 mm
Width	87 mm
Height	21.7 mm