RECORDING
43
Timer Recording
Even if a Timer Recording is set, the DVD Recorder+VCR will not record if:
• No disc is loaded.
• A non-recordable disc is loaded.
• Disc is protected in the ‘Disc Operation’ menu; see page 45.
• There are already 49 titles recorded on the disc.
You cannot enter a Timer Recording if:
• A recording is already under way.
• The start time has already passed.
• Eight Timer Recordings have already been set.
If two or more Timer Recordings overlap:
• You should set only one Timer Recording.
• You can choose replace old Timer Recording or not.
• Only one Timer recording will work.
Confirmation is not possible when:
• Disc is protected in the ‘Disc Operation’ menu; see page 45.
• There are already 49 titles recorded on the disc.
If the disc is damaged, the recording may not complete successfully, even if the Check field shows ‘Rec. OK‘.
Timer Recording Troubleshooting
You can clear a Timer Recording any time before the recording actually starts.
• Use […†] to select the program you want to erase on the Timer Recorder List. Press [■STOP] to delete the
program.
Canceling a Timer Recording
After a Timer Recording has started, you can still cancel the program by pressing [■STOP] button. To confirm,
select ‘OK‘. To cancel, select ‘Cancel‘.
Stopping a Timer Recording in Progress
Timer Recording
Recording time is overlapped with
existing entry.Replace it?
OK Cancel
If there is VPS/PDC fuction is ON, even though timer recording is completed, timer indicator might not be erased. You
have to wait until the actual VPS/PDC time signal is over.
DF-T35-37D2P-WB 2006.8.24 4:57 PM ˘ ` 43 mac001 1200DPI 90LPI
To Next Page
Loading...
Need help?
General
