SYMPTOM
OF TROUBLE
CAUSE OF TROUBLE REMEDY
Bubble comes out when put
Soap-suds on welding point
Re-weld leak-point
If cut between capillary tube and
dryer, refrigerant comes out
intermittently clogged certain part
in cooling-cycle
Exchange clogged part
Door switch is not pressed
1. Exchange door switch
pressing part or door
assembly
2. Adjust foot cause of
Cabinet inclined
Defect motor F Replace defect motor
Temperature-fuse is opened Replace temperature-fuse
Defrost-heater is opened Replace defrost-heater
Weak cooling
Defect switch bi-metal Replace switch bi-metal
Outlet voltage is not proper
Explain customer to use
refrigerator in proper voltage
Defect fuse Replace fuse
No power
Defect wire connection Reconnect
Overflow the drain case Empty the drain case
Frost is appeared around
suction pipe
Recharge proper amount of
refrigerant
Cabinet is inclined cause of
unleveled install
Use adjust feet in opposition to
former state
Leakage to
foot or front
Door inclined Adjust all hinges
14
To Next Page
Loading...
Need help?
General
