How to clean the filter
Cleaning the detergent case
* After a while detergent and fabric softeners leave a deposit in the case;
- It should be cleaned from time to time with a jet of running water.
- If necessary it can be removed completely from the machine by pressing the catch downwards and by
pulling it out.
- To facilitate cleaning, the upper part of the fabric softener compartment can be removed.
* Detergent can also accumulate inside the recess which should be cleaned occasionally with a brush.
* Once you have finished cleaning, replace the case and run a rinse cycle without laundry.
Cleaning the water inlet filter
Clean the filter when water leaks from the water inlet.
1 Pull the power plug
out before cleaning it.
2 Turn off the water
supply to the washer
and separate the inlet
hose.
3 Pull the inlet filter out. 4 Remove the dirt from
the inlet filter with a
brush.
Cleaning the drain filter
• This drain filter is used to screen the foreign stuffs such as threads, coins, pins, buttons etc..
• If the drain filter is not cleaned at proper time(every 10 times of use), drain problem could be caused.
CAUTION
Be careful when draining if the water is hot.
1 Open the lower cover(①) by
using a coin. Turn the cap
hose(②) to pull out the hose.
Pull out the hose maximally.
(About 13~14cm.)
2 Unplug the cap hose(②),
allowing the water to flow out.
At this time use a vessel to
prevent water flowing on to the
floor. When water does not flow
any more, turn the pump filter
(③) open to the left.
3 Remove any foreign material
from the pump filter(③). After
cleaning, turn the pump filter
clockwise and insert the cap
hose(②) to the original place.
Close the lower cover.
To Next Page
Loading...
Need help?
General