H O W TO U S E WA S H E R
Before washing clothes for the rst time, you must run a complete cycle without clothes.
To do these:
1. Connect the power and turn on the tap.
2. Press the “Power’ button, then turn the knob to position “Cotton”.
3. Press “start/pause”.
It can remove the water which is left in the tub because of manufacturer’s testing.
Washing preparation
1. Connect the inlet hoses well and turn on the tap.
2. After making sure the power socket is qrounded reliably, insert the power socket.
3. Place the drain hose well.
Preparation of clothes
1. Sort the laundry by colour and by care label. Most garments have a textile
care label in the collar or side seam.
2. Make sure all the pockets are empty, Foreign objects (e.g. nails, coins,
paper clips, etc.) can cause damage to garments and components in the
machine.
3. Close any zips, fasten hooks and eyes etc before washing.
4. Small delicate item (tights, baby socks) should be placed in a washing bag
or zipped pillow case.
5. Dark textiles often contain excess dye and should be washed separately
several times before being included in a mixed load. Always wash whites and coloureds separately.
6. Badly soiled areas, stains etc. should be pre-treated with liquid detergent, stain removers etc.
7. Turn over the clothes which pill easily and is with woolen surface before putting them into the machine.
Diagram 1
Diagram 2
Diagram 3
Put clothes into the washer
Unfold the laundry and load loosely in the drum. Mixing both large and small
items gives better wash results and also helps distribute the load evenly
during spinning. The most efcient use of energy and water is achieved
when a full load is washed. However, do not overload as this causes
creases and reduces cleaning efciency.
NOTE :
Make sure that no garments are caught between the door and the seal.
To Next Page
Loading...
Need help?
General
