HOW TO CLEAN THE FILTER
Cleaning the Lint Filter
Cleaning the drain filter
• In case of "Pump-Model" drain hose, this filter’s equipped at the back side of washer.
• This drain filter is to screen the foreign stuffs such as threads, coins, pins, buttons etc ..
• If the drain filter is not cleaned at proper time (every 10 times of use), drain problem could
be caused.
1Pull the filter frame upward. 2Turn the lint filter inside
out, wash the lint off
3Return the filter as it was,
and insert the filter frame
1Pull the power
plug out before
cleaning it.
2Turn off the water
supply to the
washer and
Separate the inlet
hose.
3Pull the inlet filter
out.
4Remove the dirt
from the inlet
filter with a brush.
Cleaning the water inlet filter
• Clean the filter when water leaks from the water inlet.
with water.
Filter Frame
Lint Filter
into the slot.
1Put down the remained
water in the hose. And
put a container under the
filter to collect water.
2Turn the cap counter
clockwise.
3Pull out the filter assembly
off the case.
4Clean the drain filter
removing the foreign stuffs.
5Put the filter into the case.
And turn the cap to adjust
the prominence of the filter
to the hole of the case.
6Turn the cap clockwise
tightly.
To Next Page
Loading...
Need help?
General
