6
Be careful not to confuse hot water inlet and cold water inlet.
In using only one water tap or in case of attached one water inlet valve, connect the
inlet hose to the cold water inlet valve.
For Screw-Shaped Tap
For Ordinary Tap
INLET HOSE CONNECTION
! Pull down the collar of
the inlet hose to separate
it from the water tap
adapter.
@ Loosen the four screws
properly in fitting into
water tap.
# Fit the water tap adapter
into the water tap tap
and tighten the four
screws evenly while
pushing up the adapter
so that the rubber
packing can stick to the
water tap tightly.
$ Remove the tape, and
screw connector B into
connect A tightly.
% Connect the inlet hose to
the water tap adapter by
puling down the collar of
the hose end.
^ Connect the inlet hose
adapter of the hose to
the water inlet of the
washer by turning it
clockwise to be fixed
tightly.
• Please check the rubber
packing inside the inlet hose
adapter of the hose.
! Connect the inlet hose to
the water tap by
screwing the connector
tightly.
@ Connect the connector-
inlet supplied if
necessary.
# Insert the inlet hose
adapter into the water
inlet of a washer and turn
it to be fixed.
*Cheek the packing in the inlet
To Next Page
Loading...
Need help?
General
