8
once P-HI 100%
twice P-80 80%
3 times P-60 60%
4 times P-40 40%
5 times P-20 20%
The oven light is on only when the microwave
oven is operating.
The oven door can be opened at any time
during operation by touching the door release
button on the control panel. The oven will
automatically shut off.
Each time a button is touched, a BEEP will
sound to acknowledge the touch.
The oven automatically cooks on full power
unless set to a lower power level.
The display will show “ : 0” when the oven is
plugged in.
Time clock returns to the present time when the
cooking time ends.
When the Stop/Clear button is touched during the
oven operation, the oven stops cooking and all
information retained. To erase all
information(except the present time), touch the
Stop/Clear button once more. If the oven door is
opened during the oven operation, all information
is retained.
If the Start button is touched and the oven does
not operate, check the area between the door
and door seal for obstructions and make sure the
door is closed securely. The oven will not start
cooking until the door is completely closed or the
program has been reset.
This section includes useful information about oven operation.
1. Plug power supply cord into a 230V 50Hz power outlet.
2. After placing the food in a suitable container, open the oven door and put it on the glass tray.
The glass tray and roller guide must always be in place during cooking.
3. Shut the door. Make sure that it is firmly closed.
4. Set required programme and time, then press Start.
5. Once cooking is complete take care removing container as it will be hot.
OPERATION PROCEDURE
1
2
3
4
5
6
7
8
WATTAGE OUTPUT CHART
• The power-level is set by pressing the Power button. The chart shows the display, the power level and
the percentage of power.
Touch Power button Power level (Display) Approximate Percentage of Power
Make sure the oven is properly installed
and plugged into the electrical outlet.
To Next Page
Loading...
Need help?
General
