-15-
5. SERVICE MODE
Using the Service Remote controller(R-34SVC), you can enter service mode
directly.
Key Menu Sub Menu Default Vallue Description
S1 Heat Run Mode Full White To enter into Heat Run Mode
S2
Gumi Ch Map Write Gumi Ch Map Write
To set Gumi factory channels directly
EDID Write HDMI EDID Writing automatically.
(same function on S4)
To set sound(display in sequence)
Perss S3 key again and again,
S3 Volume Test Volume Min change like this: ‘Volume Min’ -
‘Volume Middle’ - ‘Volume Max’ -
‘Balance L’ - Balance R’
When it is finished,
S4 HDMI EDID WRITE EDID Write...Wait!
display like this:
FINISH
HDMI1 EDID Success, HDMI2 EDID Success
S5 Index All On
Turn on the all LED of INDEX(Smart Icon)
S6 Panel Test To check the defective pixel of LCD
panel Using
/
buttons, 'Full Red -
Green - Blue - White - Black - Gray'
S7
DEMPOL Ch Map Write
To set DEMPOL channels dirctly
CUT OFF_R 0
CUT OFF_G 0
CUT OFF_B 0 To display offset and drive value at
S8 White Balance DRIVE_R 0 mode above
DRIVE_G 0
DRIVE_B 0
S9
MODEL SL-602M/P
Using / buttons, select between
‘SL-601T’ and ‘SL-602P’ and ‘SL-602M’
S10 Select Type
PANEL LG-32 Using / buttons, select between
'AUO_26' - 'SAMSUNG_26' - 'LG_32' -
'SAMSUNG_32' - 'LG_37' '
'
' ' ' '
BUYER Daewoo Using
/ buttons, select between
'Daewoo' and 'IRAN' and 'Newziland' -
'Others' and Indonesia
/
To Next Page
Loading...
Need help?
General