Quick Start Guide
2
2 Network Configuration
Device initialization and IP address setting can be finished with the "ConfigTool" or on web
interface.
Device initialization is required at first use or after the device being reset.
Device initialization is available only when the IP addresses of the device (192.168.1.108
by default) and the PC stay in the same network segment.
Plan useable network segment properly to connect the device to the network.
The following figures and interfaces are for reference only, and the actual product shall
prevail.
Initializing Device 2.1
Double-click "ConfigTool.exe" to open the tool. Step 1
Click . Step 2
The Modify IP interface is displayed. See Figure 2-1.
Modify IP Figure 2-1
Click Search setting.
Step 3
The Setting interface is displayed.
Enter the start IP address and end IP address of the network segment in which you Step 4
want to search devices, and then click OK.
All the devices found in the network segment are listed.
Select one or several devices whose Status is Uninitialized, and then click Initialize. Step 5
The Device initialization interface is displayed.
To Next Page
Loading...
Need help?
General
