EasyManuals Logo

Daikin Altherma HT User Manual

Daikin Altherma HT
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
User Guide – Altherma HT
8
If the radiator is too cold check that
the radiator TRV is set to a high
enough level.
A room may become warm enough without
the radiator being more than lukewarm.
Is the programmable thermostat
set too low?
Check that the temperature on the
programmable thermostat is set high enough
to start the heat pump.
Is the mains power switched o?
Check that the heating switches are switched
ON, including the switch located next to the
outdoor unit.
In the event you have checked the points
opposite, and the system still fails to operate
normally, you can manually reset the system by
turning off the power, waiting 60 seconds then
turning it back on.
If the system still does not operate
as normal, check the display on the controller
for a fault code (typically a number and a letter
for example 7H) and contact your housing
association, making reference to the
displayed code.
Your checklist for
diagnosing possible faults
www.daikin.co.uk
For full user instructions, please refer to the Daikin Altherma
operation manual.

Other manuals for Daikin Altherma HT

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Daikin Altherma HT and is the answer not in the manual?

Daikin Altherma HT Specifications

General IconGeneral
TypeAir-to-water heat pump
RefrigerantR-410A
Water Outlet TemperatureUp to 80°C
Operating Temperature Range-20°C to 35°C
Power Supply3-phase, 400V
Energy Efficiency Class (Heating)A++

Related product manuals