Instruction Si12-411A
154 System Configuration
Check
■
Before a long idle period
1. Operate the “fan only” for several hours on a fine day to dry out the
inside.
• Press “MODE” button and select “fan”operation.
• Press “ON/OFF” button and start operation.
2. Clean the air filters and set them again.
3. Take out batteries from the remote controller.
4. Turn OFF the breaker for the room air conditioner.
•
When a multi outdoor unit is connected, make sure the heating operation is not used at the other room
before you use the fan operation.
NOTE
Check that the base, stand and other fittings of the outdoor unit are not decayed or corroded.
Check that nothing blocks the air inlets and the outlets of the indoor unit and the outdoor unit.
Check that the earth wire is not disconnected or broken.
Check that the drain comes smoothly out of the drain hose during COOL or DRY operation.
• If no drain water is seen, water may be leaking from the indoor unit. Stop operation and consult the ser-
vice shop if this is the case.
•
Operation with dirty filters:
(1) cannot deodorize the air. (2) cannot clean the air.
(3) results in poor heating or cooling. (4) may cause odour.
•
To order air purifying filter with photocatalytic deodorizing function contact to the service shop there
you bought the air conditioner.
• Dispose of old air filter as non-burnable and
photocatalytic deodorizing
filters as burnable
waste.
Item Part No.
Air purifying filter with photocatalytie deodorizing
function. (without frame) 1 set
KAF952A42
To Next Page
Loading...
Need help?
General
