3
HOW TO ADJUST THE HORIZONTAL AIR
DIRECTION ANGLE
Hold the tabs on edge louvers (horizontal air outlet direction
adjustment flaps) down slightly and adjust left and right to match
the room conditions or your preference.
Stop the horizontal flaps at a position where you can hold the tabs
and adjust it left and right.
MAINTENANCE
NOTE
•
Do not remove the air filter except when cleaning.
This may cause breakage.
HOW TO CLEAN THE AIR FILTER
Clean the air filter when the display shows “ ” (TIME TO
CLEAN AIR FILTER).
• Increase the frequency of cleaning if the unit is installed in a
room where the air is extremely contaminated.
1. Open the front panel.
Place your fingers on the protrusions on the left and right
sides of the front panel and open until the panel stops.
Drain pipe
Name plate
Air inlet
(front and top of main unit)
Air filter (Inside the front panel)
Refrigerant pipe,
Transmission wire
Remote controller
Horizontal flaps
(
adjustment flaps for air outlet direction
up and down
)
Louver
(adjustment flaps for air outlet direction
to the right and left)
Air outlet
Ground wire
Provided to ground the
indoor unit to prevent an electric
shock and ensure safety
(Indoor unit model name)
01_EN_3PN07520-1 .fm Page 3 Monday, June 19, 2006 2:26 PM
To Next Page
Loading...
Need help?
General
