10
9
AIR PURIFICATION PROCESS / PREPARATION BEFORE OPERATION
For Information
PREPARATION BEFORE OPERATION
Please check before use
This product is for 220V~240V, 50Hz or 60Hz only.
Make sure to connect the power plug to a grounded electric outlet
(220V~240V, 50Hz or 60Hz) dedicated to the product.
- Always remove lter wrapping before installation.
- The unit is for residential use and thus for indoor only.
- Remove power plug from the socket when not in use.
- Check front part of the lter when installing unit.
How to install lter
Tips
1. Open the front cover by pulling
the lower part of it.
2. Take out the lter by pressing down on the top clip of the pre-lter, and remove its packing sheet.
3.
Install lters according to the following
order. Dust collection lter (electrostatic
HEPA lter)
Deodorising lter
Pre lter
(Check the insert direction of lters and
make the hooks xed into the unit.).
4. Fit the front cover back to the product.
▶
▶
▶
To Next Page
Loading...
Need help?
General
