CLEANING METHOD
■ Cleaning the Pre-Filter (Every 2 – 4 weeks)
1. Open the front cover by pulling the
lower part of it.
2. Press down on the top clip of the pre-lter and pull it out.
∗ To prevent dust from falling o, remove the lter carefully without exerting
a shock.
3. Clean the pre-lter with a vacuum cleaner or with water depending on
the level of contamination.
∗ Remove the deodorization lter before cleaning the Pre-lter.
4. Install the pre-lter after removing the moisture completely. Fit the front cover back to the product.
TIPS
- Always unplug the product before cleaning the lter.
- The pre-lter is reusable by removing dust or cleaning it with water.
- If the pre-lter is not cleaned for a long time, the product performance may deteriorate.
-
Deodorising lter and dust collecting lter cannot be cleaned and reused. Never clean them with water.
▶
∗ When retting the pre-lter to the
product, t it in the hook correctly
∗ Press the center of both sides of
pre-lter until you hear a click.
∗ When installing the front cover to
the product, hook the top left and
right corners correctly rst, and then
press the bottom.
To Next Page
Loading...
Need help?
General
