3. Remove feedback fork / setting lug (F24) from inside of end cap.
Disassembling the end cap
F24
(110, 160, 250)
F10
End cap
(typical for 110, 160, and 250 frame sizes)
side port style shown
G10
F28
F26
5 mm (110, 160, 250)
F12
F11
P104 090
All frame sizes
1. Remove servo piston (F12) from end cap (F10) glide ring end first.
2. Inspect glide ring (F10) for damage or wear.
3. Remove glide ring (F10) from servo piston if you need to replace it.
4. Remove O-ring (F11) from servo piston; discard.
5. Inspect servo piston bore in end cap for damage or wear.
51-1 Endcap
1. Remove servo piston (F12) from end cap (G10) glide ring end first.
2. Inspect glide ring (F10) for damage or wear.
3. Remove glide ring (F10) from servo piston if you need to replace it.
4. Remove O-ring (F11) from servo piston; discard.
Repair Instructions
Series 51 and 51-1 Bent Axis Motors Repair Instructions
Disassembly
14 11009449 • Rev BA • December 2014
To Next Page
Loading...
Need help?
General