Danfoss 51 Series Repair Instructions

6. Align ends of the retaining ring between the two bolt holes to allow clearance for speed sensor.
Speed sensors
Axial notch on speed sensor
Notch
Spacer ring
Sensor
Locking nut
Retaining-ring (L81)
P104 100
speed sensor
7. Install O-rings (L85) and (L90) or gasket (L82).
8. Install main housing (B10). Ensure snap ring (L81) ends align with speed sensor port.
9. Install screws (L70).
10. Torque screws:
•
32 N•m [24 lbf•ft] for 60 cc and 80 cc
•
63 N•m [46 lbf•ft] for 110 cc
•
110 N•m [81 lbf•ft] for 160 cc
Repair Instructions
Series 51 and 51-1 Bent Axis Motors Repair Instructions
Assembly
24 11009449 • Rev BA • December 2014

Danfoss 51 Series Specifications

General

Brand	Danfoss
Model	51 Series
Category	Engine
Language	English