FCM 300 Series
MG.03.B6.2G - VLT is a registered Danfoss trademark
Safety
WARNINGWARNING
WARNINGWARNING
WARNING
WARNINGWARNING
WARNINGWARNING
WARNING
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
The FCM 300 Series unit contains dangerous voltages when connected to line voltage.
After disconnection from the line, wait at least 4 minutes before touching any electrical
components. Also make sure that other voltage inputs have been disconnected. Only a
competent electrician should carry out the electrical installation. Improper installation of
the FCM 300 Series unit may cause equipment failure, serious injury or death. Follow this
manual and the National Electrical Codes (NEC
®
) and local safety codes.
Electrostatic Precaution: Electrostatic discharge (ESD). Many electronic components are
sensitive to static electricity. Voltages so low that they can not be felt, seen or heard, can
reduce the life, affect performance, or completely destroy sensitive electronic.
When performing service, proper ESD equipment should be used to prevent possible
damage from occurring.
It is the reponsibility of the user or the person installing the FCM 300 to provide proper
grounding and branch circuit protection according to the National Electrical Code (NEC
®
)
and local codes.
Motor overload protection is internal to the unit.
1-2
To Next Page
Loading...
Need help?
General
